Clutch hydraulics first and second gen.

How to's and Custum Mods
Post your How to's and any pics of any projects your doing
1 post Page 1 of 1
Our Fearless Leader
Posts: 371
Joined: Thu Jul 31, 2008 9:54 pm
Location: Innisfil ,Ont
by andrew88 » Sat Jul 10, 2010 10:16 pm
A little guide to help in the changing of your hydraulics in a first and second gen, they are a little different than the third gens but from what I've heard swappable if you change your clutch to match the generation.

So park your car on a level surface if possible, set parking brake or chock wheels.

Remove battery and air intake piping and filter box to give you a bit better room, battery tray aswell.

Unbolt the two 13mm nuts from the trans, unclip the clutch pedal from the pushrod.
slave.JPG (178.33 KiB) Viewed 2530 times

pedal.JPG (123.16 KiB) Viewed 2530 times

Now push in and turn the reservoir located on the firewall, under the main harness.
slave2.JPG (151.67 KiB) Viewed 2530 times

Push and turn on the slave cyl on the trans. Wiggle the line out and around everything. And when your done you'll have one of these laying on the ground!
hydro assembly.JPG
hydro assembly.JPG (223.18 KiB) Viewed 2530 times

Now these are a sealed system, unless you are tossing it do not loose all the fluid out of the reservoir and do nut cut or remove any of the lines.

Install in the reverse order and make sure the pushrod on the slave end sits in the clutch fork properly.
1 post Page 1 of 1
kuchnie na wymiar radomsko

Who is online

Users browsing this forum: No registered users and 1 guest